ZMC306X Motion Controller User Manual V1.5
DC power supply of the external device and the controller power supply are in the
same power supply system, this connection can also be omitted.
⚫
The E5V port is a 5V power output port, which can be used when some loads need to
provide an external 5V power input, the maximum current is 300mA.
3.5.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please use any one interface among the three interfaces ETHERNET,
RS232 and RS485 to connect to ZDevelop.
(3)
Open or close output port
directly through “
OP
” command, also, it can be
opened or
closed
through “ZDevelop/View/
Op
”. Please refer to “ZBasic” fo
r details.
(4)
The PWM function, set the
frequency and duty cycle through “PWM_FREQ” and
“PWM_DUTY”. Please refer to ZBasic for details.
3.6.
AD/DA Analog Input Output
The analog port adopts a set of 6Pin screw-type pluggable terminals with a spacing
of 3.81mm.
Summary of Contents for ZMC306X
Page 1: ......
