ZLP Electronics DigiMaster Pro3, Manual

Page: 9 / 30

To configure CW.
You may also wish to consult the DigiMaster CW interface instructions.
Put the radio in CW mode.
Configure the radio to use a standard key.
Use your CW key.
You can adjust the CW speed by adjusting the speed control on the interface.
Run your software, (any CW software that supports WinKey) and configure your software to use a
WinKey v2.3 on the port that is provided by the interface, depending on the software you are using
you may need to click on a “connect” button. You can now also send CW from your software.
When connected to your software (software permitting), you can change many parameters which
will be remembered by the interface, and which will be used even when switched OFF and back on
again and when not connected to the software. This allows you to configure the interface to your
preference and the interface will continue to operate in that way and it will stay that way until you
change them again.
Flash updateable. Flash updateable like WinKey3. Flash updates are FREE.
WinKey emulation. Set the parameters using your software and the interface will always remember your latest settings.
Direct keying support. Supports Direct keying applications that use DTR/RTS to key CW.
WinKey macros. Supports macros used in N1MM, Logger32 etc.
Software configurable. Set the parameters using your software and the interface will always remember your latest settings.
Modes. Iambic A, Iambic B, Ultimatic, Straight key, and Bug Key. (Bug key under CW firmware 3v020).
Variable speed. CW speed setting via speed pot, or software, 6 - 65 WPM.
Speed pot range. Set the min and max range for the speed pot.
Variable di/dah ratio. Default 1:3 adjustable range; 1:4 to 1:2
Adjustable weighting. Adds or subtracts a percentage to the length of every di and dah.
Adjustable compensation. Adds a fixed length to every di/dah.
Contest spacing selection. Normal or short inter character / word spaces.
Paddle Polarity. Set your own default polarity.
Tune facility .
PTT. PTT with adjustable Lead and Tail
Paddle insertion/ Break in Operating the CW key suspends PC sending
Supports ESM mode For the serious CW contest operators, the interface supports ESM.
Farnsworth
Pause Pause; on/off.
Paddle echo CW keyed on the paddle is sent back to be viewed on the PC.
Half di space Supports half di spacing..