11. TROUBLESHOOTING
11.1 “Unable to Connect” Appears
When this message appears, it means that the settings for the terminals and the com-
puters are not properly done. Find out which method you are using to connect. Refer to
Chapter 3: Connection - Syncing Terminal to further understand the topic.
11.2 “Admin Affi rm” Appears
You are not an administrator of this terminal. Only an authorized administrator of the sys-
tem is allowed to access the Menu. Any attempt of normal user to access the Menu will
prompt “Admin Affi rm” message on the screen. In case the administrator has resigned
from the company, kindly contact your authorized reseller to access the terminal.
11.3 The LED is Blinking All The Time
You have nothing to worry about unless the blinking light is red. The green light indicates
that terminal is on standby mode. Red blinking light may signal a problem in the termi-
nal. Charge your terminals for a few hours to avoid the red light from blinking. Consult
your reseller for technical advice.
11.4 RFID Card Doesn’t Respond
Two possibilities for this problem
• Have you registered the card to the terminal? The card must be registered to the
terminal before the terminal could read the information in the card. Refer to chap-
ter 8 User, page 29 for card enrollment.
• Have you assigned the user ID to the verifi cation group that supports RFID card?
Without setting the terminal that you are under a group that supports RFID card, the
terminal wouldn’t read your card.
11.5 No Sound
A few things could cause this problem:
• The terminal voice mode is silent
• Perhaps someone has turned off the voice in your terminal or reduced its volume to
0%. Refer to Chapter 5 System to under Voice to rectify.
• Speaker is damaged
• Once you have rectifi ed the voice mode and the problem persists, proceed to test
the voice. Go to Chapter 12 Auto Test to do the test. If no voice emitted, contact
your local reseller for support.
Summary
20
