ZK ZK-SAM, User Manual

Page: 46 / 66

40 ZK Celltest, Inc.
NOTE: For serial phones dual port function will not operate if the phone is
connected to the unit through a car kit. When not performing data testing,
disable the dual-port mode to allow the phone to communicate through a
car kit.
Default Setup . . .:
This selection will default all of the data testing settings back to using the
ZK Servers for FTP and HTTP (factory defaults).
NOTE: Default settings will NOT work for the Link Setup. The “Link
Setup” needs to be configured as it is dependent on the service provider
and the phone.
Setting up the Retriever Phone (PN Scanner)
By selecting the Retriever in the Phone Setup menu and the Scan_Channel
mode the following screen will appear.
There are two modes for the Retriever. In Scan_Channel mode the
Retriever scans all PNs in up to five user-defined carrier channels. The PN
Increment can be any number from 1 to 15. This value should be equal to
the PN Increment set in the infrastructure. Typically, this value is either 2
or 3. If you are not sure what the setting should be, use 1. When the PN
Increment is 1 then all 512 PNs are scanned in each channel. When it is set
to 2, then every other PN is scanned, and so on. The higher the PN Incre-
ment value the faster the scanning speed, however, only incrementally
faster. Typical scanning speed for a single carrier with a PN Increment of 2
is approximately 4 seconds.
DEVICE #1 SETUP
Class: None Phone Scanner
Type: Retriever GSM Scanner
Scan Mode: Scan_Channel Follow_Phone
Model: QCP860/Cellular QCP2760/PCS
PN Increment: 1
Number of Scan Channels: 5
Scan Channel List Setup . . .