Electrolysis Device SGM5EL Safety regulations
7
3 Safety regulations
The following regulations for industrial safety provide basic information about
potential danger during the operation of the SGM5-EL. Therefore, they must
be observed and strictly followed by the responsible staff.
•
A failure-free and functional operating of the device can only be
guaranteed with knowledge of this manual. Therefore, all chapters of
this manual must be read carefully before the installation and initiation
of the device.
•
The device is to be used for the functional operation only (see chapter
2).
The device is to be installed, operated, and serviced by trained staff
only.
•
The SGM5-EL is to be connected to an isolated ground socket
(Schuko-socket) with the supplied cable.
Explosive gas mixtures, halogens in high concentration, and sulphuric
gases (e.g. SO
2
) are not permitted to be measured by this SGM5-EL.
Due to the high operation temperature of the sensor, the SGM5-EL
produces a lot of heat.
Make sure the device does not overheat because of covering.
Switch off and disconnect the device from the power supply before opening
the housing cover of the SGM5-EL.
Condensate destroys the combination cell. If the device was used as a
humidity generator, appropriate action to prevent the combination cell from
condensate entry must be taken.
Special safety instructions for potential danger during certain working
processes are given in relevant text passages.