NOTES:
1. The depth reading is only accurate after the unit has been properly calibrated (see preceding
section).
2. The depth readings are specifically tuned for measuring 1/2 inch copper pipe or #4 rebar. For
any other metal object, the direct reading of the MetalliScanner® metal finder will be less precise.
For most sizes of rebar (other than #4), the depth reading is accurate to ±1 inch.
To get a more accurate depth for copper pipe of other diameters refer to the following conversion
table.
Operating Tips
1. When scanning with the MetalliScanner® metal finder
, hold the unit against the surface with a constant, light
pressure. Changes in pressure can cause inaccurate
fluctuations in the scanning wheel display.
2. When the Low Battery Indicator appears on the
display, replace the battery as soon as possible to
maintain sensitivity.
3. For best results when pre-scanning, move the tool at
a constant, moderate speed over the surface. Then,
once you have found a target, move slowly to pin-point
its location.
4. Since rebar may be in a grid array, scan the surface vertically and horizontally to locate its
position. You may use the depth bars to locate rebar in one direction. While still over that piece of
rebar, scan along that bar and use the scanning wheel to indicate rebar in the opposite direction
(Figure 8).
5. The MetalliScanner® metal finder is sensitive to changes in temperature. Allow 5 to 10 minutes
