WWW.
ZIPPITY
-OUTDOOR.COM
3
ASSEMBLY
INSTRUCTIONS
ZP19002
1.
It is extremely difficult to move pipe anchors once they are driven into the ground, so carefully
planning and measuring your fence is essential.
2.
After you’ve installed your first fence panel and feel familiar with the process, you can opt to
temporarily remove your fence panel and posts, and continue driving all of your pipe anchors.
3.
If you wish to cut down your fence, use a fine-toothed metal or wood blade.
4.
O
ptionally, for easier spacing of pipe anchors, you can use a piece of 1x4 wood lumber cut 70
¼” for step 2.3 on page 7.
5.
If your yard is steeply pitched or is very uneven, you may need to stair-step your panels as
illustrated below. Post heights can be trimmed down as necessary.
Warning:
If your yard has a severe slope or elevation change greater than
approximately 5” to 6” over one panel of fence, you will not be able to install
this fence. Your post will not be long enough to accommodate this slope.
minimize the gap on the lower side.
TIPS: