MAINTENANCE
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
Seite 37
Mobile Motorsense / mobile brush cutter ZI-MOS 100-4T
Seite 37
15.2.1
Clean the air filter
A clogged, dirty air filter reduces the efficiency of one motor considerably!
Loosen with a Phillips screwdriver, remove the cover of the air filter. Remove the air filter cover
and remove the air filter. Clean the air filter under running water. Wring it. Allow it to dry. Drop a
few drops of engine oil to the filter. Put the filter back on and mount the air filter cover.
15.2.2
Clean the spark plug
Remove spark plug
Unscrew the spark plug with a spark plug wrench
Visually inspect the spark plug: If the pads are worn out or the
insulation is damaged - Replace the spark plug
Clean the spark plug of impurities.
Check the distance betw the two electrodes: this should be between
0.6 and 0.7 mm.
If necessary.
Change the spark plug.
The washer should also still be in good condition.
The spark plug the screw in the first turns by hand.
With a fixed seat the spark plug with a spark plug wrench tighten ½ turn yet.
15.2.3
Carburetor
N O T E
Carburetor adjustments should be carried out only by trained specialist personnel!
15.2.4
Storage
If you store your ZI-MOS100-4T longer than 30 days:
Wailt until the machine has cooled down sufficiently.
Release the fuel from the tank and store it in a suitable vessel.
Cover the machine with a clean cloth and store it in a dry place.
15.2.5
Disposal
Do not dispose your ZI-MOS100-4T in the residual waste! Contact your
local authorities for information about best available disposal possibilities in
your area. Drain fuel from the fuel tank completely before disposing the
brush cutter. Disaggregate the machine into its components before
disposing them.
0,6
-0,7
MM
S
EALING
WASHER
-
SCHEIBE
