CLEANING, MAINTENANCE, STORAGE, DISPOSAL
44
ZI-KGS210DS
16.2.3
Setting the Laser
•
If the laser (1) does not show the correct cutting line any
more, you can adjust the laser with the screws (2).
•
The laser beam should hit the teeth of the saw blade.
16.2.4
Emptying/changing the sawdust bag
The saw is equipped with a sawdust bag (1).
NOTE:
The sawdust bag (1) may only be used for cutting wood
and wood-like materials!
•
Press the metal ring (2) on the sawdust bag (1) together
and fit it to the dust outlet (3).
•
After releasing the metal ring (2), the sawdust bag is fixed
to the dust outlet.
•
The sawdust bag can be emptied by means of a zipper (4).
16.2.5
Check / change carbon brushes
•
Check the carbon brushes after the first 50 hours of
operation with a new machine or when new brushes are
fitted. After carrying out the first check, repeat the check
every 10 hours of operation.
•
If the carbon is worn down to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is necessary
to replace both brushes. If it turns out that the brushes can
be used after removal, it is possible to remount them.
•
When servicing the carbon brushes, open the two locks
(1). Then remove the carbon brushes. Replace the carbon
brushes in reverse order.
16.2.6
Exchange table insert
CAU TION
If the table insert (1) is damaged, there is a risk that small parts may become stucked
between the table insert and the saw blade and block the saw blade
•
Remove screws (2) from the table insert (1). If necessary,
turn the rotary table and machine head to reach the
screws.
•
Remove the table insert (1).
•
Install the new table insert (1).
•
Tighten the screws (2) on the table insert (1).