ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
33
ZI-HDR40V-AKKU
18
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, UNPLUG THE BATTERY!
Trouble
Possible cause
Solution
Motor does not start
•
Battery is not plugged in
•
plug in battery
•
Battery is not charged
•
Recharge battery
•
Safety switch is damaged
•
Check safety switch
Battery cannot charged
anymore
•
Contact failure
•
Check contact pins
•
Battery damaged
•
Change battery
Fluctuating pressure
•
Pump sucking air
•
Checking the hoses and
connections are airtight
•
Valves dirty, worn out, or stuck
•
Clean or replace valves/seals
•
Pump seals worn out
•
Call the customer service center
Machine stops
•
Thermal sensor activated
•
Leave the washer for 5 minutes to
cool down
•
Nozzle partially blocked
•
Clean the nozzle
•
Battery is flat
•
Charge the battery
Machine pulsating
•
Air inlet hose
•
Allow machine to run by holding
the trigger until regular working
pressure resumes
•
Inadequate supply of mains
water
•
Check that the water supply
corresponds to the specifications
required
•
Nozzle partially blocked
•
Clean the nozzle
•
Water filter blocked
•
Clean the water inlet filter
•
Hose kinked
•
Straighten out the hose to remove
any kinks/blockages
Machine often starts and stops
by itself
•
Pump/spray gun is leaking
•
Call the customer service center
•
Trigger mechanism is broken
•
Call the customer service center
Machine starts. but no water
come out
•
Pump/hose or accessories frozen
•
Wait for pump/hose or accessories
to thaw
•
No water supply
•
Connect inlet water
•
Water inlet filter blocked
•
Clean the water inlet filter
•
Nozzle blocked
•
Clean the nozzle
N O T I C E
Should you in necessary repairs not able to properly to perform or you have not
the prescribed training for it always attract a workshop to fix the problem.
