S U P E R S P O R T
29
If the drive is not adjusted so that it is perfectly
centered over the shaft tube, the cable will rub and
quickly break.
Take your time and get this perfect. It will be much
cheaper than losing shafts and props.
Not that the fitting provided on the 3401 stinger drive
is for oil. If you grease your shaft (which we highly
recommend), you won’t use this fitting.
Leave it, remove it, it makes no difference.
Rudder
Mount the rudder with blind nuts as you have done
with the other hardware.
If using our 3413 rudder, be sure to check that the
set screw for the pin is tight. Do this before you put
the rudder blade on.
Make sure the rudder is not slanted right or left.
Use a square on the top of the boat to sight the
rudder for square.
Turn fin (s)
The turn fin should be mounted on the extreme right
side of the transom, above the trim tabs. Use the
pre-drilled holes.
We like to use 6-32x1/2 bolts and blind nuts.
Make sure the fin is 90 degrees to the bottom. It will
be canted outward with the hull level.
Not that the sharpened or beveled edge should
always face out, away from the boat.
