S U P E R S P O R T
14
Make sure that all surfaces that will touch the
sheeting are coated. Try not to use so much that it
runs all over.
Align the marks and start clamping as before,
adjusting the sheeting for equal overlap on the top
and bottom.
Line up the nose, so that the side covers half of the
keel.
You will need a few clamps.
Clamp lightly, but be careful not to distort the chines.
Check all over to be sure that the side is in contact
with the frame. If not, add clamps until it is.
Check the bottom chine near the side sheeting. It
should be flat from bulkhead 3 aft (3, 4 and 5).
If it is not, adjust your clamps so that the chines are
not distorted. This is critical.
Allow to cure at least 3 hours.
Repeat for the other side. Get the nose to fit as well
as you can. If there is a gap, don’t worry about it.
That’s what filler is for…