12
11
INSTALLATION OF SENSOR CABLE
1.
Attach the supplied self-adhesive rubber to the frame (a).
2.
Insert the smaller cable ties through the holes on the pedal sensor at the end of the
sensor cable.
3.
Attach the pedal sensor using the cable ties so that the cross (b) on the pedal sensor is
level with the magnets, the small round blank rings (c).
4.
Adjust the pedal sensor so that it sits 1-2 mm from the pedal sensor ring.
5. Insert the pedal sensor connector into the Zipforce and attach the sensor cable to the
bicycle frame with the supplied larger cable ties. Make sure that there is enough slack
on the sensor cable to the Zipforce connector for the handlebars to be turned.
6.
Tighten the pedal sensor screw using a Phillips screwdriver.
NOTE! It is very important that the pedal sensor is aligned. To test this, pedal forwards.
The red LED on the pedal sensor should then flash at a steady pace.
1.
2.
3.
4.
5.
6.
b.
c.
1-2mm
a.
