8
7
CLIP IN THE ZIPFORCE
Start by checking that the motor bracket is located leveled over the tyre.
1.
Clip in the Zipforce without screwing down the clamping screw (a). Use the pedal sensor
ring to check that the drive wheel is 2-3 mm above the tyre. Place the Zipforce into the
motor bracket so that the clamping screw aligns with the hole (b). Ensure that the lugs (c)
are in line with the slots on the motor bracket.
2.
Push the Zipforce towards the handlebars with some force. A clear ”clicking sound” can be
heard when pushed in fully. When the Zipforce is clicked into place, the holes on the side
lever of the motor bracket should be aligned. This is the lever you pull back to
remove the Zipforce.
a.
b.
c.
2.
1.
2-3 mm
