QUICK INSTALLATION GUIDE
v1.0
SMART SMOKE
SENSOR
distance from lights or decoration, and at least 15 cm from
walls. If room is more than 12 meters wide please install at 2
sides of the room.
2| SLOPING CEILING MOUNTING
If ceiling is sloping, please install the smoke alarm at
horizontal distance 90 cm away from the ceiling top.
INSTALLATION STEP 1:
Anticlockwise rotate the bracket out from the installation
base, then remove the battery insulating strip to make the
sensor to power on.
WARNINGS
1. Specifically designed for home use.
2. Avoid installation in bathrooms and other very humid places,
dusty or greasy areas, or very airy place with air conditioning,
ceiling fans, etc.
3. Keep Smoke Sensor clean. Recommended to cleane every 6
months with soft brush.
4. Effective life span is 10 years.
INSTALLATION
1| CEILING MOUNTING
The preffered location to install the sensor is in the centre
of the ceiling becase smoke, heat and combustion products
rise to the ceiling and will lateral spread. Keep at least 30 cm
INTRODUCTION
This product is a Smart Smoke Sensor, a warning device. It can
not sense gas, heat, flame and cannot prevent or put out the fire.
It is capable of real time detection of smoke, visible particles
(smoldering fire) faster than ionization smoke alarms. Red LED
flashes rapidly and detectors sound alarm once the smoke/fire
danager has been detected. Smoke alarms should be installed in
all rooms where fire may happen.
SPECIFICATION
Working voltage: DC3V (CR123A Lithium battery)
Static current: 20uA
Alarm current: 60mA
Alarm sound: 85dB/1m
Networking: Z-Wave
Working temperature: -10°C~+50°C
Humidity: 95%RH
Dimensions: 60 x 60 x 49.2 mm
TRADEMARKS
Zipato and the Zipato logo are registered Trademarks. All other
product names mentioned herein may be trademarks or
registered trademarks of their respective companies.
NOTICE
Although Zipato has attempted to ensure the accuracy of the
content of this manual, it is possible that this document may
contain technical inaccuracies, typographical, or other errors.
Zipato assumes no liability for any error in this publication, and for
damages, whether direct, indirect, incidental, and consequential
or otherwise, that may result from such error, including, but not
limited to loss of data or profits.
Zipato provides this publication “as is” without warranty of any
kind, either express or implied, including, but not limited to
implied warranties of merchantability or fitness for a particular
purpose. The published information in the manual is subject
to change without notice.Zipato reserves the right to make
changes in the product design, layout, and driver revisions without
notification to its users. This version of the Installation guide
supersedes all previous versions.
Test button and
LED indicator.
Alarm
Bracket
INSTALLATION STEP 2:
1. DEVICE INCLUSION
- Click [Add] icon in Z-Wave PC Controller Program.
- Press the Net_Button 3 times within 1.5s, Green LED is
blinking 3 times within 1 second.
- If Inclusion Process is successful, Green led will turn off.
2. DEVICE EXCLUSION
- Click [Remove] icon in Z-Wave PC Controller Program
- Press the Net_Button 3 times within 1.5s
- If Exclusion Process is successful, Green led is Blinking 6
times, then turn off.
3. DEVICE TEST MODE
If Inclusion process is successful, Press Test_Button to test if
the device is working normally. Red LED blinks 3 times when
smoke is detected.
4. DEVICE DETECTION MODE
If Inclusion process is successful, the device will report alarm
information if detect the status change of smoke and no smoke.
Red LED blinks quickly when smoke is detected.
