07
807042 v1.00 03.21 HydroTap G5 UltraCare Install Instruct
Before installation, ensure that:
• All technical specifications and instructions have been reviewed.
• There is sufficient space in the cupboard to install the Command Centre
and other components (booster heater, carbon dioxide cylinder)
in accordance with these installation instructions. Check cable and
plumbing against inlet /outlet positions before proceeding.
• The underbench can support the product weight when full of water. See
Technical specifications.
• The appliance must be connected in accordance with current local
electrical regulations. See Technical specification for power ratings. Two
user easily-accessible 220-240V AC, 10A power outlets are required.
• The appliance must be connected to a potable water supply with min/
max working pressure as outlined in the Technical specifications, with
isolating valve within reach of the hose and positioned so that the valve
will not be obstructed.
• The new hose sets supplied with the product must be used. Do not re-
use old hose sets.
• The appliance must be placed upright with its base in a horizontal
position.
In addition to standard tools, the following special tools will be required:
• 35mm diameter sheet metal hole punch for sink tops (not supplied)
• 35mm diameter hole saw for timber bench tops (not supplied)
• Nut runner tube spanner (supplied) for fixing tap assembly.
• Jigsaw and 12mm drill (not supplied) for installation of ventilation.
• Keyhole or wall board saw (not supplied) for installation of ventilation.
IMPORTANT! Do not proceed with the installation if these requirements
are not met.
Before installation
