Page 4 of 24
Hydro Tap Installation and Operating Instructions - 89026UK - June 2009
Read These Warnings First
Safety
This appliance is not intended for use by persons (including children) with
reduced physical sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
Refrigerant
The Zip HydroTap Chilling unit contains 134A refrigerant under pressure.
No part of the unit should be exposed to a naked flame. Maintenance of the
refrigeration unit must be carried out by an accredited service provider or
qualified refrigeration mechanic.
Qualifications
If any power cord or plug is damaged it must be repaired only by a qualified
technician. To avoid hazards, all installation procedures must be carried out by
a suitably qualified trades person. The power cord and general power outlet
must be in a safe visible position for connection.
Venting
Sometimes steam and / or boiling water may discharge through a vent outlet at
the mouth of the tap. If the tap is not installed using the Font pedestal, ensure
the tap body is located so the tap outlet safely drains into the sink bowl area.
NOTE:
On startup, the controls take the system through a calibration process
which causes the unit to over-boil for a period of 45 - 90 secs. This is normal
operation, once this mode is completed the system reverts back to normal
operation.
Lifting
Take care when lifting the Zip HydroTap undersink unit. Some units may
exceed safe lifting limits. Do not lift without assistance. The weights of the
units are given in the table under the heading “Installation Requirements”.
Do not lift the unit by the doors.
Airflow
The ambient temperatures this unit should operate within are 5ºC - 35ºC.
Proper air circulation must be provided. The system will operate satisfactorily
only if the recommended air gaps are provided, these are 65mm min rear
clearance and 50mm side clearance. Make sure that the ventilation grills of the
undersink unit are not obstructed.
I
ncluded in the installation pack are adhesive
backed silicon buffers. If air vents are not installed in the cupboards housing
the HydroTap, the buffers must be placed on the inside edge of the cupboard
door to create a slight gap ensuring a minimum airflow. Failure to do this may
cause the HydroTap to overheat and operate inefficiently.
Altitude (
437677UK and 37697UK.
)
The Zip HydroTap is equipped with a self-calibrating program which caters for
altitude adjustment.
The power point must be located within
reach of its cable. The appliance must be
positioned so that the plug is accessible.
Typical Zip Hydrotap undersink assembly.
NOTE:
All appliances must be placed in a
horizontal position, as shown above.
This way up
