Page 16 of 20
804721- CS_ChillTap Sparkling 09.16 v1.00
Section 6
Maintenance
6.1
Water Filter Replacement
NOTE:
For safe operation, the filter cartridge should be replaced every 6-12
months, or earlier if you notice a persistent reduction in water pressure from the
appliance or an unpleasant taste or odour in the water.
Water Filter Change:
1. Turn off the water and power supply to the unit.
2. Turn the still water lever (blue ringed lever) on, to release any water
pressure in the unit. Once water has stopped running from the tap turn off
the
lever.
3. Turn the filter clock wise and gently pull the cartridge down. The cartridge
should release from the filter head. Dispose of the filter cartridge
responsibly. Clean any water that has pooled below the filter head.
4. Fit a new filter by turning filter anticlockwise and gently pushing up. The
filter will click or lock into place.
5. Turn the still water tap on.
6. Turn on the water supply to the unit. Allow 7.5 litres to flow from the
outlet.
7. Turn off the still water lever.
8. Turn on the power supply to the unit.
Warning
Not changing filtration cartridges when required, may cause the water to become
biologically unsafe.
If the Zip ChillTap is switched off for a long period of time (e.g. More than a
weekend), run water through the chilled water outlet for at least 5 minutes before
consumption.
Use only a Zip Filter to match that used with this ChillTap (if fitted). Replacement filter
cartridges can be obtained through plumbing suppliers or directly from Zip.
Replacement instructions come with the filter cartridges.
Before attempting to disconnect or remove the filter cartridge from the housing,
isolate (turn off) the water supply prior to the filter system, and then relieve the
system pressure by operating the chilled water outlet tap until the water ceases to
flow.
1. ROTATE
2. PULL DOWN
1. INSERT
2. ROTATE
REMOVE FILTER
INSERT FILTER
