804545 03.17 1.00
Page 7 of 24
1. Insert the
fi
lter
To install a
fi
lter, insert the
fi
lter into the base of the unit as shown and turn 90° until a click or stop point is
reached, see images below. There should be approximately 20mm of the
fi
lter protuding when installed.
3. After the cover is
fi
tted, turn the tap fully
clockwise to the end stop and stopped at up-
right position.
4. Use the spanner supplied to tighten the
lock nut anti-clockwise.
2. Turn the
fi
lter through 90°
until fully engaged
20mm
Lock nut
Step 6 – Installing Filter
NOTE: For safe operation, the filter cartridge should be replaced every 6-12 months, or earlier if you
notice a persistent reduction in water pressure from the appliance or an unpleasant taste or odour in the
water. Refer to Filter Replacement section on page 21 for instructions of changing
fi
lter.
Installation Procedures
Step 7 –
Commissioning - Filter Flush & Calibrate
Remove Plug
Fig.1
Warning: Do not turn on the power until
instructed. Water must first be available from
the tap outlet to prevent damage.
1)
Remove the plug on the left side of the unit to access
the filter flush valve as shown in fig 1.
2)
Use an 8mm allen key (or flat blade screw driver) to
rotate the valve 180
⁰
(either way) to the “
FILTER FLUSH
”
position (fig 2).
