802265 v3.05 09.20 HT BCS Compact Commercial Instructions
Page 19 of 32
B
Rotate 90°
only
1
2
3
4
If no external filter
is installed, select
position A.
If an external filter
is installed, select
position B
NOTE:
Before you install a unit, determine whether a water softener or an external filter is required.
5.1
External Bypass Valve
The diverter bypass valve allows the user to choose to have the boiling feed water bypass the internal filter
and only be filtered by the external filtration. This diverter valve is located at the rear panel of the Zip HydroTap
Command Centre on the filter door side. See the diagram below to determine which filter bypass position you
need for your product.
Section 5
Command Centre Installation
A
Rotate 90°
only
1
2
3
4
5.2
Hose and tube fitting
•
Remove all caps from the top of the Command
Centre (except the mixer caps)
•
Only remove the mixer caps if a mixer tap is to be
fitted.
•
Fit the foam insulation to the Blue and to the
White tubes after trimming them to length
•
Install the mains water braided hoses to the
Command Centre before locating the unit in
place.
NOTE: Do not overtighten
Con Strainer
90° Bend end
of Braided Hose
To HydroTap
Command Centre
Braided hose for
Mains Water Supply
From Mains
Water Supply
