49
Note
：
If the available network requires authentication and data encryption, you need
to setup the authentication and encryption before step1 and all the settings
must be as same as the Access Point or Station. About the detail
authentication and data encryption settings, please refer the security section.
Authentication Type
In client mode, the device also supports two Authentication Types “Open
system” and “Shared Key”. Although the default setting is “Auto”, not every
Access Points can support “Auto” mode. If the authentication type on the
Access Point is knew by user, we suggest to set the authentication type as
same as the Access Point.
Data Encryption
In client mode, the device supports WEP and WPA Personal/Enterprise
except WPA2 mixed mode data encryption. About the detail data encryption
settings, please refer the security section.
MAC Clone for Single Ethernet Client
Enable/Disable Mac Clone (Single Ethernet Client) in Wireless-Basic Settings
page determines whether the Ethernet Client use it’s own MAC address or
AP-Client’s MAC address to transmit data. Enable MAC Clone, the single
Ethernet client can use its own MAC address. Disable MAC Clone, the single
Ethernet client must to use AP-Client’s MAC address.
While you use this device act as AP-Client and only one host connect to this
device via Ethernet, you need to check this option in this page, otherwise the
other device can’t recognize your host behind AP-Client. If you use hub/switch
connect multi-device to this AP-Client, you should uncheck this option.
