www.zi
mm
er-instruments.com
10
|
16
3.2 Programming of Transducer through Modbus(optional)
For programming of transducer, steps to be followed are
Step 1 : DIP
Switch setting:
DIP
Switches should configure for desired Output type as per given in section 3.3
Step 2 : programming
For setting Output from Current to Voltage write value
“1”.
For setting Output from Voltage to Current write value
“2”.
(Refer section 4.2 and table 3 parameters no. 16 & 18 for details).
The power supply must be applied to
Zi
mm
er
PRO
-
V
before it can be
programmed.
3.3 DIP
Switch Setting for Output
To configure
Zi
mm
er
PRO
-
V
Output, programming method to be adapted along with
mechanical switch setting (DIP
switch setting on PCB).
Type of output (current or voltage signal) has to be set by DIP
switch.
1) To change O/P switches from Current to Voltage or vice versa,
ensure that transducer should be Electrically dead and all connection wires should
be disconnected.
2) Terminal screw should be tighten.
3) Remove the Back cover of transducer by using screw driver.
Insert screw driver in a snap
fitting slot and press in
direction of arrow, remove all
snap fitting pillars of back
cover.
NOTE:
Black portion in above diagram indicate switch position.
1234
ON
1234
ON
load-independent
current
load-independent
voltage
DIP switches
Type of
output signal
Type of Output Signa
l
DIP Switch Setting
Insert screw driver in a snap
fitting slot and press in
direction of arrow, remove all
snap fitting pillars of front
cover.
4) Remove the front cover and take the Output card out.
7) After inserting the front cover insert the Interface card PCB and back cover..
1234
ON
1234
ON
Switches of Output 2,c
an be set
for desired Output type Voltage or
Current.
Switches of Output 1,c
an be set
for desired Output type Voltage
or Current.
1234
ON
1234
ON
Insert the front cover, press in direction of arrow.
6) After changing the switches for desired Output, Insert the front cover.
Insert the Interface card PCB and Back cover,
press in direction of arrow.
8) After inserting the Back cover transducer, can be used for required application..
5) Configure the switches for Voltage or Current as shown below.