INSTALLATION AND OPERATING INSTRUCTIONS:
Motor spindle, HF150-003 series
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
8
EN / 2020-10-22
DDOC00746 / -
4 Safety notes
CAUTION:
Risk of injury in the event of improper installation, commissioning or maintenance and improper use
Non-compliance may result in severe injuries!
Installation, commissioning, maintenance and repairs may only be performed by qualified specialists in
accordance with these installation and operating instructions.
The motor spindle is state-of-the-art. It is installed on industrial machines and is used to hold tools. The following
are examples of situations in which the motor spindle may pose a hazard:
•
It is not properly installed or maintained
•
It is not used for its intended purpose
•
Local regulations (legislation, ordinances, guidelines), such as the EC Machinery Directive, accident
prevention regulations and the installation and operating instructions, are not observed.
The motor spindle may be used only as intended and in accordance with the technical data. Zimmer GmbH shall
accept no liability for any damage caused by improper use.
Any use other than the intended use requires written approval from Zimmer GmbH.
Make sure that the power supply is disconnected before you install, retool or maintain the motor spindle.
Zimmer GmbH recommends performing maintenance tasks, renovation work or attachment work outside of the
machine's danger zone when possible.
When commissioning or testing, make sure that the motor spindle cannot be actuated by mistake.
Modifications to the motor spindle, such as adding drilled holes or threads, may be made only with prior
approval from Zimmer GmbH.
The specified maintenance intervals are to be observed; also refer to the "Maintenance" section. When the
motor spindle is used under extreme conditions, the maintenance interval must be adapted.
Use of the motor spindle under extreme conditions, such as aggressive liquids and abrasive dust, is subject to
prior approval from Zimmer GmbH.
Do not reach into the operating range of the motor spindle!
Notes and handling regulations for electrostatically sensitive components
Electrostatically sensitive components are individual components, integrated circuits or assemblies that can be
damaged by electrostatic fields or electrostatic discharge.
Ö
When handling electrostatic components, make sure that personnel, the work area and the packaging are all
fully grounded!
Ö
Electronic components may be touched by personnel only in appropriately identified areas with conductive
flooring and only if:
•
These persons are grounded by means of special bracelets.
•
These persons wear shoes that are suitable and approved for discharging electrostatic charges.
Ö
Electronic assemblies must not be brought into contact with plastics and parts of clothing that contain
plastic.
Ö
Electronic assemblies may only be placed on conductive underlays.
Ö
Electronic assemblies must not be installed in the vicinity of data back-up devices or monitors (monitor
distance > 100 mm).
Ö
Measurements may be performed on electronic assemblies only if:
•
The measuring instrument is grounded (e.g. via a ground conductor)
•
The measuring head is momentarily discharged before measuring with a floating measuring instrument.