ZMOTION
®
Intrusion Detection Development Kit
Quick Start Guide
QS007802-1014
Page 7 of 10
3. Place the lens and lens holder assembly onto the ZMOTION Development Board with
the arrow on the lens holder pointing up, as shown in Figure 5; use the
Primary Place-
ment
position labeled on the circuit board for the ZWA12GI12V4 lens. The four screw
holes in the circuit board should line up with the four upper mounting holes in the lens
holder.
4. Fasten each of the four (4) provided
⅜
" machine screws with a nut to secure the lens
holder in place. Figure 6 shows an example of the top of the lens holder installed on the
ZMOTION Development Board.
Figure 5. Assembled Flat 1.2" Lens Holder and Flat Lens
