ZIEHL-ABEGG ZA rec 4C Series, Original Operating Instructions

Page: 43 / 64

Parameter Designation Value range
Factory set-
ting
BR_TYP Input of the used brake resistance
Off: no brake resistance used
BR11: Brake resistor type BR11-A
BR11+BR14:
BR11 and BR14
BR14: Brake resistor type BR14
BR17-1: Brake resistor type BR17
BR25-1: Brake resistor type BR25
BR50: Brake resistor type BR50
Off
BR11
BR11+BR14
BR14
BR17
BR25
BR50
ZArec4C 013:
BR11
ZArec4C 026:
BR25
ZArec4C 039:
BR50
f_CL Input function of the input CL
ClrError: Reset the lock
LockRec: Locking of return feed function. This function is used
in conjunction with a three-phase UPS or if there is a failure of
individual phases. The energy is completely discharged via the
brake resistor.
ClrError
LockRec
LockRec
9.3 Monitoring menu
Con fi guring the monitoring functions
Parameter Designation Value range
Factory set-
ting
MOD_ERR Behaviour of the ZArec4C in case of faults
Block function: In the event that successive errors are reported
but an error-free run is performed, you have the option of block-
ing the ZArec4C. The error output (/ERR) stays open. The
counter is set to 0 when an error-free run is performed.
Never: no locking function
Lock n.3: Locking function after 3 errors. The error output
(/ERR) drops out after the 2rd error.
Lock n.2: Locking function after 2 errors. The error output
(/ERR) drops out after the 2nd error.
Lock n.1: Locking function after 1 error. The error output (/ERR)
drops out after the 1st error.
The errors that lead to locking are marked accordingly in the
error list.
Never
Lock n.3
Lock n.2:
Lock n.1
Lock n.3
UDC_MIN Input of the minimum intermediate circuit voltage
If the value drops below this minimum value, an error message
is output.
100...500 V 450
MASK1 Error mask 1...3
Suppression of up to three error messages through con
fi guring
the corresponding error number in an error mask
0...3999
0
MASK2
0
MASK3
0
9.4 Controller menu
Parameter Designation Value range
Factory set-
ting
U_DC_SR Speed with which the voltage of the intermediate circuit is in-
creased
100...1,500 V/s 1,000 V/s
9.5 Filter menu
Parameter Designation Value range
Factory set-
ting
LP_I_IN Frequency of the low pass for the input currrent
100...4000 Hz 100 Hz
Original operating instructions
ZArec4C Parameter list
R-TBA14_03-GB 1817 Index 007 Part.-No. 00163436-GB
43/64