2.9 Operator
’
s obligation of diligence
•
The contractor or owner must also ensure that the electric systems and equipment
are operated and maintained in accordance with electro-technical regulations.
•
The owner is obliged to ensure that the device is operated in perfect working order
only.
•
The device may only be used as intended.
•
You must periodically examine the safety equipment for their properly functioning
condition.
•
The assembly instructions and/or operating instructions are always readily available
at the location where the device is being used, are complete and are in legible
condition.
•
These persons are regularly instructed in all applicable questions regarding occupa-
tional safety and environmental protection and are knowledgeable regarding the
assembly instructions and/or operating instructions and, especially, are familiar with
the safety instructions contained therein.
•
All safety and warning notices attached to the device are never removed and remain
legible.
2.10 Employment of external personnel
Maintenance and service work are frequently carried out by external employees who
often do not recognize the speci
fi
c situations and the thus resulting dangers.These
persons must be comprehensively informed about the hazards in their area of activity.
You must monitor their working methods in order to intervene in good time if necessary.
3 Product overview
3.1 Area of application / Notes on use
The fans / motors are not ready-for-use products, but conceived as components for
ventilation systems (type designation see rating plate).
The fans may not be operated until they are installed in line with their intended use. The
supplied and certi
fi
ed guard grille of ZIEHL-ABEGG SE fans is designed in accordance
with DIN EN ISO 13857 Table 4 (from the age of 14 up). In the event of deviations,
further structural protective measures must be taken for safe operation.
•
Any use below -10
°
C is dependent on not being subjected to unusual, sudden or
mechanical loads or stresses on the material (see minimal permissible ambient
temperature).
•
Corrosion is possible at the cutting edges on sendzimir galvanised parts.
Assembly instructions
MAXvent
Product overview
L-BAL-F054-GB 2018 Index 005
Part.-No. 00501414-GB
11/32