chapter 4:BIOS Setting
Onboard /CNR LAN selection
Select "onboard" to enable the optional onboard LAN function.Selects "Ext.CNR
" to disable onboard LAN function and uses LAN function on CNR card.
Init Display First
Default setting is "PCI Slot", sets Init Display First to PCI Slot.
Onboard AC97 Control IDE HDD Block Mode
Enabled / Disabled IDE HDD Block Mode. Default setting is "Enabled".
Power On Function
Specifies the keyboard hot key, mouse button, power button to wakeup the
computer from S3-S5 state. Available options are Button only: Password, Hot
key, Mouse left, Mouse right, Any key, keyboard 98. Default setting is Button
only.
KB Power On Password
Sets Keyboard Power on Password.
Hot Key Power On
Sets power on Hot key. Default setting is "Ctrl-F1".
On-board FDC Controller
Enabled / Disabled on-board FDC controller. Default setting is "Enabled".
Onboard Serial Port 1 & 2
Specify the I/O port addresses of serial port 1 and 2. Available settings are Aut
o, Disabled, 3F8h, 2F8h, 3E8h and 2E8h. Default setting is "Auto".
UART Mode Select
Specifies the operation mode of onboard Serial Port 2. The onboard Serial Port
2 can be configured as an Infrared(IR) port or an ordinary RS-232 serial port.
Available settings are Normal, IrDA and ASKIR. Default is "Normal".
RxD,TxD Active
Options are "Hi,Hi","Hi,Lo","Lo,Lo","Lo,Hi".
IR Transmission Delay
Enabled / Disabled IR Transmission Delay.
UR2 Duplex Mode
This option is not available when UART is set to "Normal". Available options
are Half Duplex and Full Duplex. Default setting is "Half Duplex"
page 39
Mainboard Manual
B
IO
S
S
e
tt
in
g