water will be removed through the hose. The maximum rise may be 1.5 m from
the floor on which the device is standing. Exceeding this distance may damage the
machine or cause leaks.
During the dehumidification, the ventilator speed
can not be adjusted when
room temperature is below 25°C. Below 25°C the fan speed is fixed to “low”.
When the device is not being used in the (manual) dehumidification mode, the
plug must be removed from the water drain
.
CIRCULATING
When the air circulation mode is switched on, the transparent
1
/
2
ring around the
button on the front of the device
emits GREEN light. In this mode, the air is
circulated and filtered but not cooled, dehumidified or heated. In this mode, only
the ventilator speed can be adjusted by pressing the
-button:
Automatic regulation of ventilator speed
High
Medium
Low
HEATING MODE (PH227 + PH233)
When the heating mode is activated, the transparent
1
/
2
ring around the button on
the front of the device
emits a RED light.
The heating mode of this device works on the heat pump principle. This makes it
more efficient than a normal electric heater. The heating mode can only be
activated when the ambient temperature is below 27°C. Depending on the
outside temperature, the device will stop heating regularly in order to thaw ice
that has accumulated. The lower the outside temperature, the more frequently
this will occur. In this mode, the desired temperature can be set between 16 and
27°C.
When the device is in heating mode, both air hoses must be connected and led
outside.
ADJUSTING THE TIMER
You can use the timer function to set in advance when the airconditioner is to
4
G
NOTE!
• To prevent damage to the device, changing from the cooling or
dehumidification mode to the heating mode (or the reverse) takes
two to three minutes (PH227 + PH233).
• When Sterionizer
TM
function is switched on, positive and negative ions
are generated in every operating mode.
G
ATTENTION!
In the automatic mode, the condensed moisture is always removed
through the air exhaust hose. Removing the rubber plug from the water
drain will allow the water to drain out at this point. The water drain
can not be used.
4
62
Fan mode (green)
Heating mode (red)
27°C
16°C
Cooling
Dehumidify
Heat
man_Px2xx_1.qxd:man_P122-125.qxd5 22-12-10 15:56 Page 62
