46
A. sAFeTy iNsTRUcTiONs
install this device only when it complies with local/national legislation, by-laws and
standards.
this product is intended to be used for room heating in residential houses and is
only suitable for use in dry locations, indoors in living room, kitchen and garage.
correct installation of this stove is extremely important for product performance
and your personal safety. therefore:
•
This heater must be installed by a by Zibro authorized heating and installa-
tion engineer. the warranty can only be effective when it is installed by a by
Zibro agreed professional. the instructions for use given in this manual may
vary from local and/or regional legislation. When this is the case the most
stringent condition is applicable. Any responsibility in cases of installation
not complying to local legislation and regulation and/or in case of incorrect
air ventilation and/or inappropriate use is explicitly declined by the manu-
facturer and distributor.
•
The stove must only be installed in a room where the location, the building
construction and the use of the room do not interfere with safe operation
of the stove.
Always contact your dealer or installer immediately in case you experience problems
with your stove or when you have difficulty reading or understanding this manual.
burning wood needs oxygen, thus air. ensure to allow sufficient fresh air to enter
the room. per hour an additional 50 m
3
air is needed above the normal ventilation
requirement for the room. Always have a fresh air inlet to the room with a section
of at least a quarter of the section of the exhaust flue, with a minimum of 100 cm
2
.
it might be necessary to shut off mechanical ventilation and/or kitchen extraction
hoods as this might negatively influence the draught needed for the stove.
•
Use proper equipment to transport the stove. Using not adequate equip-
ment might lead to personal injuries and/or damage to the stove.
•
Do not place any inflammable ob�ects and/or materials within 80 cm. of the
sides and back of the stove and not within 100 cm to the front of the stove.
•
The stove is designed for free standing and is not suitable for build-in. Keep
30 cm clearance between walls and side/back of the stove.
•
When the floor is made of inflammable material, place the stove on a fire
proof base plate. the covered area by the fire proof base plate needs to be
50 cm. larger to the front of the unit and needs to be 30 cm. larger measured
from the sides of the unit (see picture 1, dimensions d and e)
•
In case the walls are made out of inflammable materials make sure to have
sufficient distance from side/back of stove to the wall. make sure that even
at highest stoking rate the wall temperature can never exceed 80°c. in case
of doubt a fire proof protective plate must be placed.
4
NOTe!
All the pictures in this manual and on the gift box are for
explanation and indication purpose only. they may be slightly different
from the appliance you purchased. the actual shape shall prevail.
G
