Zhuhai RaySharp Technology RS-CH772H1B-36-RF, User Manual, Page: 7 / 27

User Manual
6
3. Device Operation Instructions
3.1 Check Connection
1. The default factory IP address for IP camera is 192.168.1.125and the subnet mask is 255.255.255.0.
Allocate to your computer an IP address in the same network segment as the IP camera, for example,
192.168.1.69, and a same subnet mask as that of the IP camera.
2. Test whether the IP camera is connected properly and started normally by clicking on Start > Run and
entering "cmd" and pressing ENTER, and entering "ping 192.168.1.168" in the command line window to
Check whether the IP camera is accessible. If the PING command is executed successfully, it indicates that the IP
camera operates normally and the network is connected properly. If the PING command fails, check IP address
and gateway setting of the PC and connectivity of the network.
3.2 Searching Device
Tips: IPC Device Search may be used for device searching across network segments. Before running IPC
Device Search, click on the local connection icon at the lower right corner of the desktop;
1. Add IP addresses of several network segments in TCP/IP setting for local connection (as shown below). By
running the searching tool you can search any device with IP address in the same network segment.
Note:
IPC Device Search uses multicast protocol for device searching across segments but any firewall forbids traffic of
multicast data packets, so any firewall must be disabled in order that network the information on device can be