10
Mounting to the Workbench
1.
Get the stickers from the foot pads delivered with the equipment,
and attach the pads to the bottom of the equipment where
appropriate.
2.
Place the equipment on a clean workbench. Now the installation
process is complete.
Mounting into a Cabinet
WARNING!
Ensure that the cabinet is equipped with a tray or slide rail before
installing the equipment in a cabinet. The equipment must be supported
on a tray or slide rail instead of a suspension loop.
1.
As shown in the following figure, place the suspension loop with a
screw hole close to the chassis. Align the suspension loop with
the screw hole, and use two M4*8 screws to fasten the
suspension loop to the chassis.
2.
Perform the same procedure to mount the suspension loop on
the other side of the chassis.
1: Screws (4)
2: Slotted hole
3: Suspension loop
3.
Place the equipment on the cabinet support, and slid it into the
cabinet. Fix the suspension loop to the floating nut to the front
mounting bar of the cabinet with screws led through the slotted
hole.
1 2
3
