Zgonc Yellow Profiline YPL 1100, Translation Of The Original Instructions

Page: 10 / 15

10
Addition
Waring: (1) Please stop the tool when you want
to change the running direction and change by
pressing switch. (2) The troque will vary bigger
from longer running time. When you want
to assemble or unassemble a bolt, you want
keep the tool running more than 5S. But when
keeping running more than 5S, it is not meaning
the toruqe will be bigger and bigger.Please refer
to the diagram, this clause is not suit for variable
torque wrench.
Diagram
Remark:It is suit for unvariable torque wrench
1. When the voltage is 10% less than rated,will
result in the forward torque decreasing rapidly.
(Please refer to diagram).
2. When choose wrong sockets also can result in
torque decreasing.
3. The torque will vary from different size of bolt.
Layout (B1)
1. ON/OFF switch - Reversing switch
2. Square drive mount (mounting shaft)
APPLICATION
Tools can be used for tire changing,shock
absorber replacement, exhaust system work,
lawn mower repair and small engine work,
assembling and unassembling the bolt and nut.
choose the right sockets suit for the size of the
square drive. If use wrong sockets will result in
inaccurate torque and damaging the bolt and
tool. The specification of bolt,nut and required
torque must accord with the precision class of
the bolt, nut and national standard. When there
is high request of torque, please check and
remedy the torque frequently by the torque test
equipment.
Please refer to the table technical below to
adjust the right torque according to different
size of bolt.
Size of Bolt Torque(N.M)
M10-M12 40-80
M12-M16 100-200
M14-M16 120-200
M18-M24 200-350
Do not use tool if switch does not turn it on or
off. Any tool that connot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing
accessories,or storing the tool. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
Store idle tools out of reach of children and
other untrained persons. Tools are dangerous in
the hands of untrained users.
Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools with
sharp cutting edges are less likely to bind and
are easier to control.
Check for misalignment or binding of moving
parts,breakage of parts, and any other condition
that may affect the tools operation. If damaged,
have the tool serivced before using. Many
accidents are caused by poorly maintained
tools.
Use only accessories recommended by the
manufacturer for your model. Accessories that
are suitable for one tools, may become hazards
when used with another tool.