Zgonc Yellow GARDEN LINE 720 YGL N.G. NEW GENERATION, Translation Of Original Instruction Manual

Page: 52 / 64

4 Carefully pivot the snow thrower up and forward so that it rests on the auger hous-
ing.
5 Remove the frame cover(s) from the underside of the snow thrower by removing
the screws which secure the cover(s).
6 Remove the belt(s) from around the auger pulley, and slip the belt(s) between the
support bracket and the auger pulley.
7 Replace the auger belt(s) by following instructions in reverse order.
Drive Belt
If the drive belt becomes worn, oil-soaked, or otherwise damaged, proceed as follows
to replace the belt.
1. In order to prevent spillage, remove the fuel from the tank by closing the fuel valve
and running the engine until it stops. Then, open the tank cap and let the petrol
completely drain into a sufficiently large container by tilting the machine or sucking
it out. Then, close tank cap again.
2 Remove the two screws that hold the belt cover in place and set the cover aside.
3 Remove the belt as follows.
a. Roll the auger belt(s) off the engine pulley.
a. Pivot the idler pulley toward the right to relieve tension.
a. Lift the drive belt off engine pulley.
4 Carefully pivot the snow thrower up and forward so that it rests on the auger hous-
ing.
52
D GB