Installation and operating instructions V00 77
This device is equipped with two fans located on the right side. If the fan does not run
normally or makes any unusual noise, clean the fans or replace the broken fans. To do
so, disconnect the inverter from all power sources, and wait approx. 30 minutes until
the inverter has cooled down. Unscrew the fan bracket (Screwdriver type: T25) and
remove the fans out of the inverter by pressing on the cable locking hooks of the fans.
Loosen the screws securing the fan by a Phillips screwdriver. Then the fan can be
cleaned using a soft cloth or a brush or be replaced. After
maintenance
, reassemble
the fans back(Torque: 0.7Nm)and tighten 4 screws on the fan bracket with a
screwdriver (Type: T25, torque: 2.5Nm).
Damage to the fan due to compressed air!
• Clean the fan only with a soft brush, a paint brush, or a damp cloth.
Summary of Contents for Zeverlution Pro 33K.
Page 1: ......
