37
seti2c (SET Input to 2 Continuous)
This command is essentially a short cut to 1 of 5 of the most obvious configurations for the
deployment of the system.
The seti2c command:
Sets the input to Input 2 (non quadrature).
Sets Unipolar Mode.
Disables Overflow Indication.
setiqbc (SET Input to Quadrature Bipolar Continuous)
This command is essentially a short cut to 1 of 5 of the most obvious configurations for the
deployment of the system.
Sets the input quadrature using inputs 1 & 2 (Input 1 Leads).
Sets Bipolar Mode.
Disables Overflow Indication.
setiqbo (SET Input to Quadrature Bipolar Overflow Continuous)
This command is essentially a short cut to 1 of 5 of the most obvious configurations for the
deployment of the system.
setiqc (SET Input to Quadrature Continuous)
This command is essentially a short cut to 1 of 5 of the most obvious configurations for the
deployment of the system.
setlbft
Set the display to show readings in lbft. (The scale factor must still be determined in Nm. A
conversion factor of 0.737562121 is applied to the Nm reading.)
setnm
Set the display to show readings in Nm. (No conversion factor is applied.)
set8rate
Set 8 digit Volume and Flow Meter
setratebot
Set 4 Digit Rate Display on Display 2.
setratetop
Set 4 Digit Rate Display on Display 1.
setround
Sets the display rounding on, and thereby defeats the truncation of the displayed value.
setsas
Set 4 digit analogue system on display 1
setsasbot
Set 4 Digit Analogue System on Display 2.
setsastop
Set 4 Digit Analogue System on Display 1.
setsasbot
Set 4 Digit Analogue System on Display 2.
setstrain
Set non TVS mode (strain gauge mode).
