PREMIER M PLUS INSTALLATION MANUAL
Approved Document No: GLT.MAN-111
PAGE
8
Issue : 2.8 Author: NJ Date: 23/07/2012
4. MOUNTING THE FIRE ALARM PANEL
When working alone, it is recommended that the panel door be removed to avoid accidental damage. Also, the termination PCB
could be removed and stored in a safe place while fixing the back box to the wall.
4.1 PLANNING CABLE ENTRY
Fig.2 below shows the location of the cable entries to facilitate planning of wiring (home runs) to be brought to the panel.
The grommets can be easily removed by a push from inside the control panel box.
If a grommet is removed, fill the hole with a brass cable gland. If any knockout is removed, but subsequently not used, it should be
covered up.
The 230Va.c. Mains cable must be fed into the enclosure via one of the cable entries at the top right corner of the back box. (Refer
to “Connecting the Mains” on Page 10).
4.2 FIXING THE BACK BOX TO THE WALL
Figure 2: Plan view inside the enclosure without PCBs. Side view for surface installation.
Fix the enclosure to the wall using the three mounting holes provided.
Check the build material & condition of the wall to decide a suitable screw fixing.
The mounting holes are designed for No 8 roundhead or countersunk woodscrews (or similar).
Remove any debris from the enclosure.
Take care not to damage the FACP during installation.
