PREMIER QUATRO USER MANUAL, MAINTENANCE GUIDE & LOG BOOK (Fyreye MKII)
#Doc No. GLT-215-7-2
PAGE 10
Issue: 1.08 Author: TE/NJ Date: 26/05/2017
6. THE FAULT CONDITION
The fire alarm panel monitors itself, and any equipment connected to it, for any faults that can occur. If a fault occurs, the panel
responds by activating its Internal buzzer and lighting the General Fault light and any other Fault light(s) relevant to the particular
fault. The panel will also display the fault on its LCD display. The Panel’s Fault relay will also activate. If there is more than one fault,
the MORE DATA LED will light. The user can either wait for each fault to be scrolled automatically on the LCD, or scroll manually
through the list of faults using the
◄
and
►
buttons.
6.1 FAULT INDICATIONS
The panel has the following yellow flashing FAULT LEDs:
SUPPLY FAULT, COMMON FAULT, EARTH FAULT, SYSTEM FAULT,
OUT OF SERVICE FAULT, which can be found at the top right of
the LED display as shown.
Two blocks below this in the section headed OUTPUT FAULTS /
DISABLEMENTS are 2 LEDs which notify the user of SOUNDER
FAULTS and RELAY FAULTS.
To the left of this are 20 LEDs which are used to indicate Zone
Faults / Disablement / Test in Zones 1 – 20.
COMMON FAULT
The Common fault LED is lit for all types of fault.
SUPPLY FAULT
This indicates a loss of Mains power or a loss of Battery power or a loss of Battery Charger or a Battery with a High Resistance.
Battery Fault indicates that there is no battery connected to the panel. Charger Fault indicates there is a problem with the mains
supply (or one of its fuses). If the mains supply fails, the panel will only operate for the standby period dictated by the size of the
batteries fitted. If the batteries or charger fails at the same time as the Mains, the Panel will be inoperative.
OUT OF SERVICE FAULT
This is lit when the battery voltage has dropped to a value at which the alarm system is no longer fully functional (following a period
when the mains service is not supplied to the panel).
ZONE FAULT
The relevant zone fault light will flash when there is a wiring problem on a Zone or detector has been removed from its base. It
should be noted that any alarms raised on the fault zone(s) may not be recognised by the Fire Alarm Panel until the Fault Conditions
have been cleared. It can take up to 10 seconds from repairing a fault for the display to clear.
