English - 26
© 2022 ZES - All rights reserved
IG v1.0.0 01.2022
7-
Carefully insert the flattened, arranged wi-
res into the connector, pushing through until
the wire ends emerge from the pins.
8-
Check to make sure that the wire ends
coming out of the connector’s pin side are in
the correct order. If you realize that a mistake
has been made in wire order after termina-
tion, you’ll have to cut the connector off and
start all over again!
9-
Insert the prepared connector/cable
assembly into the RJ45 slot in your crimping
tool. Firmly squeeze the crimper’s handles
together until you can’t go any further. Relea-
se the handles and repeat this step to ensure
a proper crimp.
10-
If your crimper doesn’t automatically trim
the wire ends upon termination, carefully cut
wire ends to make them as flush with the
connector’s surface as possible. The closer
the wire ends are trimmed, the better your
final plug-in connection will be.
11-
Termination is complete.
12-
Insert the RJ45 connector to the socket as shown in figure below.
Table.1