Zeroplus Arduino starter kit with Logic Analyzer, Manual

Page: 77 / 123

76
• Connect the components as shown on the schematic.
• Connect the channel A0 of the logic analyzer to the anode of the
LED and the channels A1 to A5 of the Logic Analyzer to the pins
3 to 7 of the Arduino UNO board.
• In ZP Studio, set the trigger to rising edge on A0, because the
signal is rising when the LED turns on, and that’s what we want
to detect.
• In ZP Studio, create a bus with the channels A1 to A5.
• Click on Run.
• The value marked by the trigger bar is the one we are looking for.
This value is randomly generated everytime the board is reset.
PROCEDURE
Logic Analyzer A0 A1 A2 A3 A4 A5 A6 A7 clk
Arduino UNO LED 3 4 5 6 7
PROCEDURE