ZERONE ZEUS-150, Operation Manual

Page: 37 / 41

ZEUS-200S/150 ZO-OM-007
REV : 08 35 ZERONE
Table 202
Guidance and manufacturer ’ s declaration – electromagnetic immunity
ZEUS-200S/150 model is intended for use in the electromagnetic environment specified below. The
customer or user of the ZEUS-200S/150 model should ensure that it is used in such an environment.
Emissions test EN/IEC 60601 test
level
Compliance level Electromagnetic environment -
guidance
Electrostatic
Discharge (ESD)
IEC 61000-4-2
± 8 kV contact
± 2 kV, ± 4 kV, ± 8
kV , ± 15 kV air
Complies
± 8 kV contact
± 15 kV air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the relative
humidity should be at least
30%.
Electrical fast
transient/burst
IEC 61000-4-4
± 2 kV
100kHz repetition
frequency
± 2 kV
100kHz repetition
frequency
Mains power quality should be
that of a typical commercial or
hospital environment.
Surge Line-to-
line
IEC 61000-4-5
± 0.5 kV, ± 1 kV ± 1 kV Mains power quality should be
that of a typical commercial or
hospital environment.
Surge Line-to-
ground
IEC 61000-4-5
± 0.5 kV, ± 1 kV, ± 2
kV
± 2 kV
Voltage dips
IEC 61000-4-11
0% UT; 0.5 cycle
At 0 ° ,45 ° ,90 ° ,135 ° ,
180 ° ,225 ° ,270 °
and 315 °
0% UT; 0.5 cycle
At 0 ° ,45 ° ,90 ° ,135 ° ,
180 ° ,225 ° ,270 °
and 315 °
Mains power quality should be
that of a typical commercial or
hospital environment.
If the user of the equipment or
system requires continued
operation during power mains
interruptions,
it is recommended that the
equipment or system be
powered from an
uninterruptible power supply or
a battery.
0% UT; 1 cycle
And 70% UT; 25/30
cycles single phase: at 0 °
0% UT; 1 cycle
And 70% UT; 25/30 cycles
single phase: at 0 °
Voltage
interruptions
IEC 61000-4-11
0% UT; 250/300 cycle 0% UT; 250/300 cycle
RATED Power
frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
30 A/m 30 A/m Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical
commercial or hospital
environment.
* Note: UT is the a.c. mains voltage prior to application of the test level.