INEX SUCTION BLAST CABINET with 300 CFM RECLAIMER
Page 11
© 2005 CLEMCO INDUSTRIES CORP.
•
www.clemcoindustries.com
•
Manual No. 21803 Rev. D 03/05
Figure
13
6.3.11.
Repeat steps 6.3.9 and 6.3.10 on the other end
of the filler strip. Use the window stick to push the filler
strip into the molding at any spot the strip is not fully
seated. Place the light-shield in its normal position.
6.4
Dry Filter Tube Replacement, Figure 14
CAUTION
•
Do not bend spring ends tight enough to
cause ends to kink.
•
Do not use a sharp instrument to force
spring rings into the opening. This could
damage the filter and seriously impair the
function of the dust collector.
•
Install one filter at a time. Check the seating
of the top and bottom spring rings, and that
tube is not twisted, before proceeding to the
next.
6.4.1
Replace damaged filters immediately. Remove
the old filters by pulling the spring rings off the bottom
and top tube plates. Working from the back to the front,
install one filter at a time. To install new filters, form the
end of the spring ringed tubular filter into a shallow "c"
shape, push the filter far enough into the hole of the top
plate to allow one spring ring to snap into place above
the tube plate and the other to snap into place below it.
See the illustration in Figure 14.
Figure
14
6.4.2
The tubular filter is held firmly by spring rings
above and below the perimeter of the hole in the top and
bottom tube plate. The filters fit tight to prevent dust
leakage. Force may be required by the installer. Check
for proper seating at both ends, and remove any twist in
the tube before proceeding to the next filter.
6.5 Dust
Bag
6.5.1
Replace the bag at first sign of dust leak, or as
necessary to maintain visibility in the cabinet. If visibility
is poor, periodic washing may restore the porosity of the
cloth and increase ventilation through the cabinet.
6.6 Reclaimer
Wearplate
Replacement
6.6.1
Remove the reclaimer inlet adaptor and old
wearplate. The wearplate is held in place by screws
attached from the outside of the reclaimer.
6.6.2
Angle the new wearplate into the reclaimer inlet
until it is in position with the straight end at the reclaimer
inlet. Using a board or similar object as leverage, pry the
wearplate against the inner wall of the reclaimer and
install sheet metal screws to hold in place. Caulk any
gaps or voids around the wearplate to prevent rapid
wear in those areas.
Bottom Tube Plate
Top Tube Plate
Spring Ring
Spring Ring
One ring above tube plate
One ring below tube plate
