Zero COMANDO 24, User Manual And Configuration

Page: 3 / 16

PG3
ZCOMV2 |CONTROL PANEL | COMANDO 24V
CONTENTS
1. SAFETY INSTRUCTIONS
STANDARDS TO FOLLOW
2. THE CONTROL BOARD
TECHNICAL SPECIFICATIONS
PROGRAMMING PRE-RECOMENDATIONS
3 CONFIGURATION
DIP-SWITCHES FUNCTION’S BOARD
4. TROUBLESHOOTING
5. FINAL CONSUMERS INSTRUCTIONS
INSTRUCTIONS FOR SPECIALIZED INSTALLERS
6. WIRING DIAGRAM
7. CONTROL BOARD COMPONENT CONNECTION
1. SAFETY INSTRUCTIONS
STANDARDS TO FOLLOW
ATTENTION:
•To ensure the safety of people, it is important that you read
all of the following instructions. Incorrect installation or incor -
rect use of the product may cause physical injury and material
damage.
•Keep these instructions in a safe place for future reference.
•This product was designed and produced strictly for the use
indicated in this manual. Any other use, not expressly indicated
here in, could compromise the good condition/operation of the
product and/or be a source of danger.
•ZERO SRL is not responsible for the improper use of the pro -
duct, or other use than that for which it was designed.
•ZERO SRL is not responsible if safety standards are not taken
into account when installing the equipment, or for any defor-
mation that may occur to it.
•ZERO SRL is not responsible for the safety and proper opera -
tion when using components not sold by them.
•Do not make any modification to the operator components
and / or their accessories.
•Before installation unplug the automation from the mains
power supply.
•The installer must inform the client how to handle the product
in case of emergency and provide this manual to the user.
•Keep remote controls away from children, to prevent the au-
tomated system from being activated involuntarily.
•The customer shall not, under any circumstances attempt to
repair or tune the automation and must call a qualified techni -
cian only.
•Connect the automation to a 230V plug with ground wire.
•Control board for indoor use.
2. THE CONTROL BOARD
TECHNICAL SPECIFICATIONS
Power supply:
12/24 VAC 80W
Lightbulb’s output:
24 VDC 10W max
Motor’s output:
1x24V 60W max
Aux. accessories output:
12 VDC 8W, max
Working temperature:
-20°C a +50°C
Radio Receptor:
Incorporated 433,92 Mhz
OP Transmitters:
Rolling Code
Max. memory capacity:
200 codes max
CONNECTOR’S DESCRIPTION
M1 Connector
01 • 12V battery input
02 • 0V battery input
03 • Motor’s input (+) positive
04 • Motor’s input (-) negative
05 • Light bulb connection output (-) negative
06 • Light bulb connection output (+) positive
07 • Power supply output for accessories 12V AC - 8W máx.
08 • Power supply output for accessories 0V
M2 Connector
09 • Pedestrian START input (NA)
10 • Open/close input (NA)
11 • Safety device input PHOTOCELLS- complete direction
inversion (NC)
12 • STOP button’s input (NC)
13 • Safety device input EDGE- 2 seconds inversion (NC wire )
14 • Opening limit-switch input signal (NC)
15 • Closing limit-switch input signal (NC)
16 • Safety device and start input common
M3 Connector
17 • Antenna cable screen input
18 • Antenna input
D Connector
19 • 0V VCA transformer supply input
20 • 12V VCA transformer supply input
21 • 20V VCA transformer supply input