zero
HOME AUTOMATION
PG3
ZCOM230 |CONTROL PANEL | COMANDO 230V
CONTENTS
1.
SAFETY INSTRUCTIONS
STANDARDS TO FOLLOW
2.
THE CONTROL BOARD
TECHNICAL SPECIFICATIONS
PROGRAMMING PRE-RECOMENDATIONS
3.
DIP SWITCHES
DIPPERS FUNCTION’S BOARD
4. CONFIGURATION
INSTALATION PROCESS
5. TROUBLESHOOTING
FINAL CONSUMERS INSTRUCTIONS
INSTRUCTIONS FOR SPECIALIZED INSTALLERS
7.
WIRING DIAGRAM
CONTROL BOARD COMPONENT CONNECTION
1. SAFETY INSTRUCTIONS
STANDARDS TO FOLLOW
ATTENTION:
• To ensure the safety of people, it is important that you read all
the following instructions. Incorrect installation or incorrect use
of the product can cause physical injury and material damage.
• Keep these instructions in a safe place for future reference.
• This product was designed and produced strictly for the use
indicated in this manual. Any other use, not expressly indicated
here, could compromise the good condition/operation of the
product and/or be a source of danger.
• ZERO SRL is not responsible for the improper use of the pro
-
duct, or other use than that for which it was designed.
• ZERO SRL is not responsible if safety standards were not taken
into account when installing the equipment, or for any defor-
mation that may occur to it.
• ZERO SRL is not responsible for the safety and proper opera
-
tion when using components not sold by them.
• Do not make any modifications to the operator components
and / or their accessories.
• Before installation unplug the automatism from the source
of power.
• The installer must inform the client how to handle the pro-
duct in case of emergency and provide this manual to user.
• Keep remote controls away from children, to prevent the au-
tomated system from being activated involuntarily.
• The customer shall not, under any circumstances, attempt to
repair or tune the automatism. Must call qualified technician
only.
• Connect the automatism to a 230V plug with ground wire.
• Control board for indoor use.
2.
THE CONTROL BOARD
TECHNICAL SPECIFICATIONS
Power supply:
230V 50/60Hz
Lightbulb’s output:
AC230V 40W max
Motor’s output:
AC230V 750W max
Aux. accessories output:
AC24V 8W máx
Working temperature:
-20°C a +50°C
Radio Receptor:
Incorporated 433,92 Mhz
OP Transmitters:
12 bits ou Rolling Code
Max. memory capacity:
200 codes max
CONNECTOR’S DESCRIPTION
M2 Connector
01 • Closing limit-switch input signal (NC)
02 • Opening limit-switch input signal (NC)
03 • Open/close transmitter button’s input (NA)
04 • Safety device input - complete direction inversion (NC)
05 • Pedestrian transmitter button’s input (NC)
06 • Safety device input - 2 seconds inversion (NC)
07 • Safety device input common / STARTs
08 • Power supply output for accessories 0V
09 • Power supply output for accessories 24V AC - 8W máx.
M1 Connector
10 • Light bulb connection’s output (230Vac)
11 • Light bulb connection’s output - common
12 • Light bulb connection’s output or courtesy light
13 • Motor’s output - Opening
14 • Motor’s output - Common
15 • Motor’s output - Closing
16 • 230V line input (neutral)
17 • Not used
18 • 230V line input (phase)
M3 Connector
19 • Antenna
20 • Antenna cable screen
M4 Connector
21 • Place Shunt for motors up to 500kg (included)
22 • Remove Shunt for motors up to 500kg
PROGRAMMING PRE-RECOMENDATIONS
Before proceeding to the control board configuration, note the
following points listed in the table below in order to better un
-
derstand the control board function:
