AEROLYTE 6060A and 7070A G2 PRESSURE CABINETS
Page 25
© 2016 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 27789 Rev. A, 10/16
Turntables and Turntables with Tracks
WARNING
Turntable capacities are based on concentric
loading. Use solid fixturing to hold heavy parts
in place. Do not remove lift equipment until the
part is adequately supported to prevent
movement. Moving or rotating heavy,
unsupported or off-centered parts may cause
them to shift or topple, and cause severe injury.
Fixed-base Turntable with Bearing, 500 lb. Capacity,
Figure 26
Item
Description
Stock No.
(-)
30" diameter .............................................. 14138
(-)
40" diameter ............................................. 24042
(-)
48" diameter, for 7070A only .................... 13845
1.
Turntable, replacement
30" diameter 500 lb. capacity ................ 21390
40" diameter 500 lb. capacity ................ 23879
48" diameter 500 lb. capacity ................ 21400
2.
Bearing, 1-1/2" bore (48" table requires 2) 11517
3.
Protector, bearing ..................................... 13479
4.
Bolt, 1/2-NC
2” long for 30" and 40" turntable ........... 03456
2-1/2” long for 48" turntable ................... 03457
5.
Lock-washer, 1/2" ..................................... 03516
6.
Nut, 1/2-NC hex ........................................ 03511
Figure 26
Turntable with Workcar and Track
2000 lb. capacity turntable mounted on workcar with
9 ft. (nominal) track extension
30"
diameter
for 6060A ..................................... 25550
48"
diameter
for 6060A ..................................... 27055
48"
diameter
for 7070A .................................... 25555
Turntable with Workcar, 2000 Capacity, Figure 27
Item Description
Stock
No.
1.
Turntable, replacement
30" diameter for 6060A and 7070A ....... 27727
48" diameter for 6060A and 7070A ....... 27728
2.
Bearing, 1-1/2" bore, 1 req’d for 30” table
2 required with 48" table ......................... 11517
3.
Protector, bearing ..................................... 13479
4.
Wheel, 6" V groove ................................... 12220
5.
Bolt, 1/2" shoulder .................................... 13477
6.
Washer, 1/2" flat ........................................ 03515
7.
Nut, 3/8 lock .............................................. 03312
8.
Bolt, 1/2-NC
2" long for 30" turntable ......................... 03456
2-1/2” long for 48" turntable .................. 03457
9.
Washer, 1/2" lock ..................................... 03516
10.
Nut, 1/2-NC hex ........................................ 03511
11.
Pin, quick release ..................................... 25540
Figure
27
* Lower bearing not used
with 30-inch turntable.
1
2
3
10
9
11
5
6
7
8
*2
4
1
3
2
5
6
4
2
