20 • Plumbing
Pump with Bracket Installation Instructions
PLUMBING
BEFORE SETTING AND SHIMMING THE CASE
1. Locate the vinyl tubing shipped inside the display case. There will be a primary tube (16' long), which is used for the discharge line
between the condensate pump outlet and the evaporation pan, and a secondary tube (8' long) for the overflow line. For cases that share
a single evaporation pan ("pan sharing"), the primary case will require both a discharge line and an overflow line. The secondary case will
require only a discharge line.
2. attach the vinyl tubing to the back of the case using the supplied P-clips and screws. Route enough tubing under the case to connect to
the pump outlet, which will be mounted to the front of the case, and leave enough tubing to reach the condensate evaporation pan on top
of the case. For pan sharing, spread out the tubing so there is enough to reach from the pump of one case to the evaporation pan on the
other.
3. Place the condensate evaporation pan on top of the case.
Discharge
Line from
Second Case
Add
P-Clips
Parts Required:
Cable ties
Case drain lateral
Condensate evaporation pan
Condensate pump
Copper pipe
Hose clamp
P-clip clamp
Piping support bracket
Pump support bracket
Screws
Vinyl tubing
Vinyl tubing with PVC elbow
Wire clamp
Pan Sharing Shown
Discharge
Line
Overflow
Line
Condensate
Evaporation Pan
Add
P-Clips
