19.
4.8 TRIMMING
Trimming is used to balance out your drone if it is drifting when flying.
To adjust the trimming please follow the steps below.
1. Make sure that the Remote Control and Hydra are switched on and
correctly paired.
2. Hold the Trimmer button on the rear of the Remote Control.
3. While still holding the Trimmer button use the right thumb stick to
counter the direction that your Hydra is drifting.
4. As you are adjusting the trimming the beep tone will go lower the
more that you trim in any directing.
PLEASE NOTE
: If Trimming is not fixing the drones drifting, you may need
to re calibrate your drone by turning off the drone and the controller and
restarting the instructions in the Getting Started section of this manual.
4.9
RETURN TO HOME
Return to home brings the Hydra back to the location it was launched
from.
To activate Return to Home press the Return to Home button on the front
of the remote control.
PLEASE NOTE:
It is important that the GPS is correctly connected before
launch before activating return to home. Failing to do so may result in the
drone flying away when return to home is attempted.
4.10 POINT OF INTEREST
When activated, point of interest will make the Hydra circle around the
desired point of interest.
To activate Point of interest aim the Hydra at the desired point of interest
and then press the right thumb stick in like a button and the controller will
beep.
While in Point of Interest mode the left thumb stick is used only to
control the Hydra’s height and the right thumb stick is used to control the
direction and speed that the Hydra circles the target and how close the
Hydra is to the target.
