ZHD 1500/2000-135/155/175
48
Connection unit
www.zepro.com
11.2.2
Fault codes
If a fault arises, the fault code is shown in the display in the form of a letter for identifying the fault, followed by numbers
and/or number segments for further information, followed by sensor indication (C) in accordance with the previous page.
In fault codes E, F and U, the numbers (1-9) show which control device/output the fault code refers to.
Control card con-
nection
Recommended control device
1
CTRL 1
Fixed control device 1, including two-hand button 2h1
2
CTRL 2
Fixed control device 2, including two-hand button 2h2
3
CTRL 3
Radio control device, External
4
CTRL 4
Coil control device
5
CTRL 5
Slider lift control device
6
CTRL 6
Radio control device, internal module
7
CS
CS (cabin switch)
8
Control Power
9
Sensor Power
If the system discovers several faults, only the fault code for the fault with the highest priority will be
shown automatically. The display is prioritised in the order in the table below, L/H, E, F and A. To see
all current faults, press and hold in button C on the control device.
When the CS is switched off, the system will browse through a list containing the five most recent faults de-
tected before the display goes off after approx. 5 minutes, the control card then goes into power save mode.
Fault codes
Identification
Code 1 Code 2
Code
3
Information
Other
L
Low battery voltage
07-35
Voltage measured
H
High battery voltage
07-35
Voltage measured
E
Control device
locked
1
Fixed control device 1 (incl. two-hand
button 2h1 if they are monitored)
B
C
E
X
In
Out
2
Fixed control device 2 (incl. two-hand
button 2h2 if they are monitored)
3
Radio control device, external
4
Coil control device
5
Truck slider control device
6
Radio control device, internal module
7
CS (cabin switch)
Segment
Segments B, C, E or X are il-
luminated depending on which
button signal has locked the
control device.
Summary of Contents for ZHD 1500-135
Page 2: ......
