ZHD 1500/2000-135/155/175
Installation
29
www.zepro.com
2
3
5
4
End stop
Adjusting collar
Lock screw
The tilt angle must be set at 90° to the
vehicle body before the downward tilt
angle is adjusted (see previous page).
NOTE.
To ensure that the lift is safe and CE
compliant, the downward tilt angle
must be adjusted to max. 10° if there
are going to be people on the platform.
m
WARNING!
1. Operate lift up so that the platform
reaches the vehicle floor. Fig. 47.
2. Loosen the lock screw of the end stop
(2). Screw the end stop all the way
back towards the platform (3). Fig. 48.
3. Tilt the platform down to max. 10
degrees below the horizontal. Fig. 47.
4. Adjust the end stop all the way to the
top of the cylinder (4). Fig. 48.
5. Tighten the lock screw in the end stop
(5). Fig. 48.
The tightening torque for lock screws is 3-5
Nm
Test all functions.
6.10.2
Adjusting the downward tilt angle
Bolt
Washer
Fig. 47. The tilt angle must be ad-
justed to max.10° down
Fig. 48. End stop with lock screw
Fig. 49. Tilt cylinder
Summary of Contents for ZHD 1500-135
Page 2: ......
