ZHD 1500/2000-135/155/175
24
Installation
www.zepro.com
6.6
Armstops
Fit end stops between the lift arms and
the rear member of the vehicle floor.
The left and right end stops must be
reached at the same time, as high up
the lift arm as possible. Installation must
take place against the vehicle body.
It is not permitted to perform welding
in the lift arm. Installation must take
place against the vehicle body.
m
WARNING!
6.7
Angle sensor for autotilt
When installing the angle sensor on the
lift arm, see Fig. 34.
When installing on the left arm, the
sensor’s cable input must be facing
upwards.
When installing on the right arm, the
sensor’s cable input must be facing
downwards.
NOTE.
Fig. 33. Fit end stops between the lift arms
and the rear member of the vehicle floor
6.8
Sealing strip (horizontal)
The track is fitted using the self-tapping
screws provided.
1. Mark where to drill holes for the
self-tapping screws.
2. Drill holes (Ø 7.2 mm) for the
screws.
3. Fit the horizontal stop strip (steel or
aluminium).
4. Fit the rubber strip to the track.
6.9
Sealing strip (vertical)
1. Fit the tracks with countersunk
screws, rivets or by spot welding.
2. Fit the rubber strip to the track.
3. Secure the rubber strips by swaging
the tracks together at the bottom.
To fit an upper edge seal, create
a 45° mitre against the vertical
strips.
NOTE.
Fig. 34. Installing the angle sensor
Fig. 35. Installing a sealing strip
Left
Right
Summary of Contents for ZHD 1500-135
Page 2: ......
