Z 45/75-90/110
Installation
31
www.zepro.com
4.9
Arm stops
Arm stops are not included in standard equipment.
Can be ordered separately, part. no. 53450 for Z/ZU/
ZL/ZLU and part. no. 53869 for ZN/ZNU models.
1. Fit arm stops as high up as possible on the lift arm.
Ensure that the adjustment screws have a good
contact area against the rear member of the vehicle
floor. If needed, fit a stop on the rear member so as
to create a stable contact surface for the arm stop.
2. Adjust with the adjustment screws, so that both arm
stops make contact with the rear member/stop at
the same time.
NOTE!
When installing arm stops, use Loctite 243 or equiva
-
lent on the fixing screws, see Figure 44.
NOTE!
If an assembly kit has been used for assembling the
support frame , there may be special instructions for
arm stops in the separate assembly directions for the
assembly kit.
Image 38. Fit end stops between the lift arms
and the rear beam of the vehicle floor
min - max
100 mm
Image 39. U
se Loctite 243 or equivalent
on the fixing screws
m
WARNING!
Welding on the lift arm is not permitted.
Summary of Contents for Z 45-110
Page 2: ......